Testing The Printer; Plugging In The Printer; Running The Self Test - Epson LQ-1070+ User Manual

Testing the Printer

Before connecting your printer to a computer, use the built-in
self-test function to see that the printer is working properly.
Before running the self test, you need to plug your printer's
power cord into an electrical outlet.

Plugging in the printer

1. Make sure the printer is turned off.
2
Check the label on the back of the printer to make sun2 the
voltage nquired by the printer matches that of your
electrical outlet.
3.
If the power cord is not attached to the printer, connect it to
the AC inlet on theprinteis rear par&
4. Plug the power cord into a properly gxxmded electrical
outlet.

Running the self test

You can run the self test with either ctM.nuous paper or single
mar, front, or bottom. The following steps describe how to run
the test on
single-sheet paper, loadd fmm the top. See Chapter
2
for full details on paper handling.
the rated voltage and your outlet voltage do not match,
Setting Up the Printer 1-9