Epson LQ-1070+ User Manual page 109

Regular g&s occur in the printout.
One-inch
off.
Skip over-perforation is set, but the perforation does not fall in
the center of the 82dp.
Make sure the page-kngth DIP-switch setting matches the
page length
If your software
switch l-8 off.
Vertical printed lines do not align.
DIP switch 1-5 on for &dire&o nalprinting.
When clearing the buffer, you also lose the top&4orm.
6-6 Troubleshooting
of your paper. See page 3-9.
controls the top and bottom margins, set DIP
setup menu. See page I-14