Epson FX-1180+ User Manual page 31

2. Make sure the printer is turned off, and the printer cover is
removed. Also make sure the tractor is installed in the pull
position and the paper guide is lying flat on the printer.
3. Set the paper release lever to the pull
tractor position.
4. Release the sprockets by pulling the
sprocket lock levers forward.
5. Slide the left sprocket approximately 12 mm (0.5 inch) from
the far left position and push the lever back to lock it in
place. Then slide the right sprocket to match the width of
your paper, but do not lock it. Move the center support
midway between the two sprockets.
6. Make sure your paper has a clean, straight edge. Then open
the sprocket covers.
Paper Handling
2-9