Epson FX-1180+ User Manual page 26

4. Slide the left sprocket approximately 12 mm (0.5 inch) from
the far left position and pull the blue lever forward to lock it
in place. Then slide the right sprocket to match the width of
your paper, but do not lock it. Move the center support
midway between the two sprockets.
5. Remove the front cover by pulling it straight down, as
shown below.
6. Make sure your paper has a clean, straight edge. Then open
both sprocket covers and fit the first four holes of the paper,
with printable side up, over the tractor pins.
2-4
Paper Handling