Skip Over Perforation - Epson FX-1180+ User Manual

Setting
International character set for
italic table (options vary
depending on the country)
Manual feed wait time
Buzzer
Auto CR (carriage return)***
IBM character table***
Bottom margin*
Line spacing (lines per inch)*
Paper out override*
* Available only in Okidata mode. (See page 3-11 for more information.)
** Not available in Okidata mode.
*** Available only in IBM PPDS emulation mode.
Page length for front tractor
This setting allows you to set the page length (in inches) for the
continuous paper loaded on the front push tractor.
Page length for rear tractor
This setting allows you to set the page length (in inches) for the
continuous paper loaded on the rear push tractor.

Skip over perforation

This feature is available only when continuous paper is selected.
When you turn on this feature, the printer provides a one-inch
(25.4 mm) margin between the last line printed on one page and
the first line printed on the next page. Because most application
program margin settings override margin settings from the
control panel, you should use this setting only if you cannot set
your top and bottom margins using your application.
Options
Italic U.S.A., Italic France, Italic Germany,
Italic U.K., Italic Denmark 1, Italic Sweden,
Italic Italy, Italic Spain 1
1 second, 1.5 seconds, 2 seconds, 3 seconds
Off, On
Off, On
Table 2, Table 1
4.2 mm, 20 mm, 22 mm, 24 mm, Others
6 LPI, 8 LPI
Off, On
Using the Control Panel
3-5