Epson FX-1180+ User Manual page 64

The default settings (shown in bold) are consistent with Okidata
Microline 320 Turbo factory settings.
Note:
Because the ML 320T does not have a built-in USB interface, the
FX-880+ does not support the USB interface in Okidata mode.
If you want to use your printer in Okidata mode, do not install
®
the Windows driver that came with your FX-880+. If you have
been using an Okidata driver, you can continue to use it with
your FX-880+ in Okidata mode.
If you have been using an Okidata printer, you may want to
print out its default settings for reference before changing
modes on the FX-880+. To do this on the ML 320T, press SHIFT +
SEL to enter Menu mode, and then press PRINT.
To enter Okidata mode, make sure the printer is turned off.
Then hold down the Tear Off/Bin and Pause buttons while you
turn on the printer. The printer beeps once to indicate it is now
in Okidata mode.
The printer remains in Okidata mode until you repeat the above
procedure. To return to FX-880+ mode, hold down the Tear
Off/Bin and Pause buttons while you turn on the printer. The
printer beeps twice and is now operating in FX-880+ mode.
Note:
When you switch from one mode to the other, any changes you made to
the printer's settings in the original mode are restored to their default
values. You can print the default settings for the printer when it is in
Okidata mode to check the current settings and change them if
necessary. See "Changing default settings" on page 3-9.
3-12
Using the Control Panel