Finding a Plarc for the Printer
If you install
the
additional 4 inches (100 mm) directly above the printer.
CAUTIONS:
Avoid locations that are subject to direct sunlight,
excessive heat, moisture, or dust.
Avoid using electrical outlets that are controlled by
wall switches or automatic timers. Accidental
disruption of power
information in your computer's memory and printer's
memory.
Avoid using outlets
motors or other appliances
power supply.
Keep the entire computer and printer
from potential sources of interference, such as
loudspeakers or the base units of cordless telephones.
Opening the printer cover
The printer cover opens to two positions, as shown on the
following page. When you lift
it stops automatically in the lower position (at an angle of about
45 degrees). This position protects
overexposure to light. When you lift
it stops at the upper position (about 70 degrees). The instructions
in this manual tell you which position to use for
1-4
Setting Up the Printer
optional lower paper cassette, you need an
wipe out valuable
can
the same circuit with large
on
might disturb the
that
latch to open the printer cover,
the
imaging cartridge from
the
cover as far as it will go,
the
system away
task.
each