Brother Quattro 6000D User Manual page 20

p
Select the area containing one of the two
stickers, and then press
→ The camera detects the two marks.
Note
• To return to the sewing screen, press
Pressing , then
connection setting screen (screen for connecting the
selected pattern to the previous one), where the
reference edge and reference point can be selected.
• If the following message appears, press
and then rehoop the fabric so that the centers of the
large circles of the positioning stickers are within the
embroidering area or hoop the fabric in a larger
embroidery frame. After checking that the area
containing one of the two stickers have been
correctly selected in step
The message above also appears when the
positioning sticker is too closely attached to the
perimeters of the embroidering area. In that case,
rehoop the fabric so that the stickers fit more within
the embroidering area.
• If the following message appears, press
and then rehoop the fabric so that the pattern and
the centers of the large circles of the positioning
stickers are within the embroidering area or hoop
the fabric in a larger embroidery frame.
.
.
displays the pattern
,
p
, press .
,
If the positioning stickers do not fit within the
embroidering area, press
shown below.
Next, press
pattern connection setting screen.
Refer to "CHANGING THE POSITION OF A
STICKER" on page 22 to reposition the sticker.
• If the following message appears, press
return to the pattern editing screen. Check the
pattern size and pattern connection settings, and
then repeat the previous steps.
q
After the positioning stickers have been
detected, press
stickers.
in the screen
, then to display the
to
, and then remove the
19