Postscript Mode; Hp Emulation Mode - Epson EPL-7500 Manual

EPL-7500 LASER PRINTER
Installation/Support Tips
Software

PostScript Mode

For PC users: choose EPL-7500 from the printer selection
menu in the application program. If the menu does not list
EPL-7500, choose any PostScript printer.
For Macintosh users: check your Macintosh documentation
for instructions on installing a printer. lf the EPL-7500 is not
listed among the printer options, choose the LaserWriter.

HP Emulation Mode

1. lf the application program does not support the PostScript
language, or if the program was written specifically for the HP
LaserJet, then configure the printer to HP emulation mode.
Then choose the first printer available in the list below from
the application program's printer selection menu.
HP LaserJet series IIP
HP LaserJet series II
HP LaserJet +
HP LaserJet 500
HP LaserJet
Set Up
The EPL-7500 is factory-set for the parallel interface. To use
another interface, you must change the INTERFACE setting in
SelecType level 2 and save the new setting. After changing
and saving the setting, turn off the printer before attaching the
Interface cable, or the printer could be damaged.
If an AppleTalk cable is connected, never operate the printer
with the SelecType INTERFACE option set to any other
interface. Failure to use the AppleTalk setting may leave the
printer inoperable or bring down the entire system.
To print complex pages, it may be necessary to increase the
printer's amount of memory by adding a memory board.
EPL-7500-10 1/7/91 Laser Printers