Status And Error Messages - Epson EPL-7500 Manual

Epson laser printer specification sheet
Hide thumbs Also See for EPL-7500:
Table of Contents

Advertisement

Status and Error Messages

If an error occurs, your best source of information is the display on
the control panel. The error messages displayed there tell you what
is wrong and, in some cases, indicate the actions you should take
to correct the problem.
Status messages also appear on the display during the printer's
normal operation. They indicate the printer's current status.
This section contains an alphabetical list of status and error
messages you may encounter and includes the steps you need to
take to correct any problems. SelecType messages are not included.
Status messages are preceded by [S], warning messages are
preceded by [W], and error messages are preceded by [E]. In some
cases the message you see on your display also shows the printer
mode.
[E] COVER OPEN
The printer cover is open or the imaging cartridge is not
installed. Close the printer cover or install the imaging
cartridge.
[E] LOW ON TONER
The imaging cartridge must be replaced. Replace the imaging
cartridge as described in Chapter 6.
[E] MANUAL FEED
This message appears when manual feed is selected. The
printer is ready to print a page and is waiting for paper to be
fed manually.
OFF LINE
The printer is off line and not in the SelecType mode. In this
status, you can enter SelecType mode by pressing the
S e l e c T y p e b u t t o n .
OUT OF PAPER
No paper cassette is installed, or there is no paper in the
standard paper cassette and the optional lower paper cassette
(if installed), or the paper set lever is in the manual position
and you are not feeding pages correctly. Insert more paper
into the selected paper cassette or manually feed a sheet of
paper into the printer. See Chapter 4 for more information on
loading paper.
PAPER ENTRY JAM
Paper is not feeding into the printer from the specified
cassette or has jammed on its way into the printer. If the
paper is jammed at the paper cassette, open the printer case,
remove
the jammed paper from the standard paper cassette or
optional paper cassette and then close the printer. See the
PAPER ENTRY JAM section later in this chapter for more
information.
PAPER EXIT JAM
Paper is jammed inside the paper path. You need to open the
printer and clear the jammed paper as described later in this
chapter.
PRINTING
The printer has received data and is printing.
[S]
PRINTING TEST
The printer is printing the test page.
PROCESSING
The printer is processing data.
Laser Printers
QUIT
The ON LINE button was pressed while a print job
progress. The job can then be flushed by pressing the RESET
button, or a reset can be cancelled by pressing any other
button.
QUITTING THE JOB
The printer is flushing a job from the buffer.
READY
In PostScript mode, the printer is between jobs and has
nothing to process from the communication channels. You can
use the control panel while the printer is ready.
RESETTING
This message appears initially when the printer is first started
up and momentarily between jobs.
WAIT FOR READY
The ON LINE button was pressed while a print job was in
progress. The printer continues printing until the current job
is completed; then it goes off line.
WAITING
The printer is in the process of executing a job and has run
out of data and is waiting for the channel to provide more
data.
WARMING UP
The printer is warming up,
Service faults
The service messages listed below are caused by a printer
malfunction and can sometimes be serious:
SCAN MOTOR ERROR
HSYNC ERROR
HEATER LAMP ERROR
MAIN MOTOR ERROR
FAN MOTOR ERROR
If one of these error messages appears, follow the steps below.
1. Press the RESET button.
2. If the error does not clear, turn the printer off for at least five
seconds. Then turn it back on.
3. If the problem remains, service is required. Write the message
down and turn the printer off. Then contact a qualified service
person or your dealer.
Clean the transfer charger wire by gently rubbing the cotton
swab along the length of the wire, as shown below. Only wipe
from left to right when cleaning the transfer charger wire.
not moisten the cotton swab.
1/7/91
EPL-7500 LASER PRINTER
THE JOB
was in
EPL-7500-9

Advertisement

Table of Contents
loading

Table of Contents