Adjusting Print Density; Testing The Printer - Epson EPL-7500 Manual

EPL-7500 LASER PRINTER
SelecType Level 2

Testing the Printer

When you turn on the printer, it automatically prints a start page,
containing simple text and graphics. Normally, processing of the
start page begins about 70 seconds after you turn the printer on.
The start page does not print if the STARTPAGE option in
SelecType Level 2 is set to OFF or if the printer takes more than
three minutes to warm up,
EPL-7500-6
Note: In most cases, leave the STARTPAGE option set to on.
The start page lists useful information about your printer's
current settings and lets you know the printer is working
properly and ready to print.
You can also print test prints with the TEST PRINT option in
SelecType Level 2. See Chapter 3.
EPSON EPL-7500

Adjusting print density

You can control the overall density of the printed image with the
print density control knob. If your test print is too light or too
dark, adjust the print density as follows:
1.
Lift the latch to open the printer cover to the lower position.
2. Locate the yellow density control knob inside the front right
comer of the printer, as shown below.
1/7/91
Laser Printers