Setting The Work Clamp Mode; Setting Solenoid Work Clamp Mode; Setting Pneumatic Work Clamp Mode - Brother KE-434C Instruction Manual

14. SETTING THE WORK CLAMP MODE

14. SETTING THE WORK CLAMP MODE

14-1. Setting solenoid work clamp mode

Through the combination of DIP switches A-1 and A-2 on the operation panel, presser motions can be set as follows:
DIPA-1 DIPA-2
ON
ON
ON ON

14-2. Setting pneumatic work clamp mode

Through the combination of DIP switches A-1 and A-2 on the operation panel, presser motions can be set as follows:
When memo-42 = 0 (initial value for all specifications other than inner clamping specifications)
DIPA-1 DIPA-2
ON
ON ON
ON
Special memo-42 settings for pneumatic specifications
memo-42 Pedal specifications
5 Two pedals
6 Two pedals
7 Two pedals
Three pedals
8
(Option)
9 Two pedals
10 Two pedals
60
Pedal specifications
Single pedal Presser is raised automatically. (factory default settings)
Single pedal Presser is raised by pressing the pedal.
Presser is raised automatically, then it is lowered by pressing
Two pedals
the pedal.
Two pedals Presser is kept lifted while the presser pedal is pressed.
Pedal specifications
Single pedal Presser is raised automatically.
Single pedal Presser is raised by pressing the pedal.
Presser is raised automatically, then it is lowered by pressing
Two pedals
the pedal. (factory default settings)
Two pedals Presser is kept lifted while the presser pedal is pressed.
Left presser drops when presser pedal is at the 1st step, and right presser drops
when presser pedal is at the 2nd step.
Raising is carried out in the reverse order.
* Initial value for inner clamping specifications only
* Setting used when using the light work clamp function (Refer to "14-3. Light work
clamp".)
Right presser drops when presser pedal is at the 1st step, and left presser drops
when presser pedal is at the 2nd step.
Raising is carried out in the reverse order.
The left/right operating sequence changes alternately for each item sewn when
using two-pedal operation.
Starts with right left.
The left pedal is used to raise and lower the left presser, and the right (center) pedal
is used to raise and lower the right presser.
The start (right) pedal is used to start sewing.
Furthermore, when DIP switch A-2 is at ON, and if one presser is already lowered,
pressing the start pedal causes the other presser to be lowered and then sewing
starts.
When the presser pedal is depressed to the 1st step, both left and right pressers are
raised simultaneously.
When it is pressed to the 2nd step, sewing starts.
When the start pedal is depressed, both left and right pressers are lowered
simultaneously.
When the start pedal is released, sewing starts.
KE-434C,435C
Raising the presser at the sewing end
Raising the presser at the sewing end
Raising the presser at the sewing end