Brother KE-434C Instruction Manual page 60

12. CHANGING FUNCTIONS USING THE DIP SWITCHES
Using a user program
1. Press the DISPLAY SET switches (10) to select the speed program number for the user program that you would
like to use.
* The user program except P16 can also be selected using the user program switches (11). (See below.)
2. Depress the foot switch to the second step.
3. Check the sewing pattern (see P.26), and then sew the pattern selected.
* P1 to P4 can be selected using the P1 to P4 user program switches (11). P5 to P15 can be selected by pressing the P1 to
P4 switches together in various combinations as shown below.
The switches with solid lines are valid switches for selection.
To select P5
To select P11
Clearing the user programs
1. Switch the machine to recording mode by the procedure in steps 2. of recording a user program.
2. Use the DISPLAY SET switches (10) to specify the user program number which is to be cleared of data.
3. Press the RESET switch (12).
* The buzzer will sound and the user program with the number selected will be cleared.
* If you press and hold the RESET switch (12) until after the buzzer has sounded twice, all user programs will be cleared.
Note:
If data has been recorded in user programs P1, P2, P3 and P4 and you then clear the data in user program P2, the
contents of P3 will be transferred to P2, and the contents of P4 will be transferred to P3.
54
To select P6 To select P7
To select P12 To select P13
To select P8
To select P14
KE-434C,435C
To select P9 To select P10
To select P15
0472Q