NOTE:
You may be need to remove existing top and side covers installed on the server before
installing the covers shipped with the wheel kit. If cover removal is not needed, go directly to
the next sections for installing the top and side cover.
Figure 2-14 Cover Locations
Removing the Top Cover
The following section describes the procedure for removing the top cover.
1.
Connect to ground with a wrist strap.
2.
Loosen the blue retaining screws securing the cover to the chassis
3.
Slide the cover toward the rear of the chassis.
4.
Lift the cover up and away from the chassis.
5.
Place the cover in a safe location.
48
Installing the System
(Figure
2-15).