This PDU might be referred to as a Relocatable Power Tapoutside HP.
The PDU installation kit contains the following:
•
PDU with cord and plug
•
Mounting hardware
•
Installation instructions
Installing Additional Cards and Storage
This section provides information on additional products ordered after installation and any
dependencies for these add-on products.
The following options can be installed in the server:
•
Hard disk drive storage
•
Removable media device storage
•
PCI/PCI-X I/O cards
Installing an Additional Hard Disk Drive
The disk drives are located in the front of the chassis
hot-plug drives.
A list of replacement disk drives for the server is in Appendix A of the HP Service Guide. The
list contains both removable media disk drives and hard disk drives.
Figure 2-17 Disk Drive Location
Use the following procedure to install the disk drives:
1.
Be sure the front locking latch is open, then position the disk drive in the chassis.
2.
Slide the disk drive into the chassis; apply a slow, firm pressure to properly seat the connector.
3.
Press the front locking latch to secure the disk drive in the chassis.
(Figure
2-17). The hard disk drives are
Installing Additional Cards and Storage
51