TDK-Lambda GENESYS 1500W Technical Manual page 7

TABLE OF CONTENTS
5.15.1 Basic parallel operation..............................................................................
5.15.2 Advanced parallel operation........................................................................
5.16 DAISY-CHAIN SHUT-OFF CONNECTION.............................................................
5.17 FRONT PANEL LOCKING..................................................................................
5.17.1 Unlocked front panel.................................................................................
5.17.2 Locked front panel....................................................................................
CHAPTER 6 REMOTE ANALOG PROGRAMMING......................................................
6.1 INTRODUCTION................................................................................................
6.2 LOCAL/REMOTE ANALOG CONTROL..................................................................
6.3 LOCAL/REMOTE ANALOG INDICATION................................................................
6.4 REMOTE VOLTAGE PROGRAMMING OF OUTPUT VOLTAGE AND CURRENT...........
6.5 RESISTIVE PROGRAMMING OF OUTPUT VOLTAGE AND CURRENT.......................
6.6 REMOTE MONITORING OF OUTPUT VOLTAGE AND CURRENT..............................
CHAPTER 7 RS232 & RS485 REMOTE CONTROL......................................................
7.1 INTRODUCTION................................................................................................
7.2 CONFIGURATION..............................................................................................
7.2.1 Default setting.............................................................................................
7.2.2 Address setting...........................................................................................
7.2.3 RS232 or RS485 selection............................................................................
7.2.4 Baud rate setting.........................................................................................
7.2.5 Setting the unit into Remote or Local mode.......................................................
7.2.6 RS232/458 port at Local mode.......................................................................
7.2.7 Front panel in Remote mode.........................................................................
7.3 REAR PANEL RS232/485 CONNECTOR................................................................
7.4 MD MODE OPTION (Factory Installed)...................................................................
7.4.1 MD Mode Description..................................................................................
7.4.2 MD Mode enable - Serial communication mode.................................................
7.4.3 MD Mode SRQ...........................................................................................
7.4.4 Communication Collisions.............................................................................
7.4.5 MD Mode SRQ Retransmission.....................................................................
7.5 CONNECTING POWER SUPPLIES TO RS232 OR RS485 BUS..................................
7.5.1 Single power supply.....................................................................................
7.5.2 Multi power supply connection to RS232 or RS485 BUS......................................
7.6 COMMUNICATION INTERFACE PROTOCOL.........................................................
7.6.1 Data format................................................................................................
7.6.2 Addressing................................................................................................
7.6.3 End of message.........................................................................................
7.6.4 Command repeat........................................................................................
7.6.5 Checksum.................................................................................................
7.6.6 Acknowledge..............................................................................................
7.6.7 Error message............................................................................................
7.6.8 Backspace.................................................................................................
7.7 ERROR MESSAGES..........................................................................................
7.8 COMMAND SET DESCRIPTION...........................................................................
7.8.1 General guides...........................................................................................
7.8.2 Command set categories..............................................................................
7.8.3 Initialization control commands.......................................................................
7.8.4 ID control commands...................................................................................
7.8.5 Output control commands.............................................................................
7.9 GLOBAL OUTPUT COMMANDS..........................................................................
7.9.1 General.....................................................................................................
7.10 SINGLE BYTE COMMANDS..............................................................................
7.10.1 General...................................................................................................
7.10.2 Global commands without response..............................................................
7.10.3 Global commands with response..................................................................
7.10.4 Addressed commands with response............................................................
7.10.5 Addressed commands without response........................................................
83-507-013 Rev. D
Pg. 41
Pg. 42
Pg. 45
Pg. 44
Pg. 44
Pg. 44
Pg. 45
Pg. 45
Pg. 45
Pg. 45
Pg. 46
Pg. 47
Pg. 48
Pg. 49
Pg. 49
Pg. 49
Pg. 49
Pg. 49
Pg. 49
Pg. 49
Pg. 49
Pg. 50
Pg. 50
Pg. 50
Pg. 51
Pg. 51
Pg. 51
Pg. 51
Pg. 51
Pg. 51
Pg. 52
Pg. 52
Pg. 53
Pg. 53
Pg. 53
Pg. 53
Pg. 53
Pg. 53
Pg. 53
Pg. 53
Pg. 54
Pg. 54
Pg. 54
Pg. 54
Pg. 54
Pg. 54
Pg. 55
Pg. 55
Pg. 55
Pg. 57
Pg. 57
Pg. 58
Pg. 58
Pg. 58
Pg. 59
Pg. 59
Pg. 59