GE Profile PNSF31Z01 Owner's Manual page 9

Timer Settings Required
Upon installation and after an extended power outage. See the
Program Memory section.
Set Present Time of Day
NOTE: If the words PRESENT TIME do not show in the display, press
the SELECT button until they do.
1
2
SmartWater Softening System
RECHARGE TONIGHT
TOUCH
or
RECHARGE NOW
HOLD
Profile
When the transformer is plugged into the electrical outlet
12:00 AM is flashing and PRESENT TIME shows in the display
area. Program the timer as instructed below. If SR- - is flashing,
use the UP button to set the correct SR code as follows: SR22. If
you pass by the correct code number, use the DOWN button.
Then, press the SELECT button and program the timer below.
... If the wrong SR code shows for your model, see Manually Initiated
Electronic Diagnostics section.
A "beeper" sounds while pressing buttons for timer
programming. One beep signals a change in the timer display.
Repeated beeps mean the timer will not accept a change from
the button you have pressed and you should use another button.
To set the timer, you will use the UP, DOWN and SELECT
buttons.
Press the UP or DOWN button to set. The UP button moves
the display ahead; the DOWN moves the time backward. If the
present time is between noon and midnight, be sure PM
shows . If the present time is between midnight and
noon, be sure AM shows
When the present time shows in display, press SELECT to set.
TIME
SELECT
HARDNESS
.
9