GE Profile PNSF31Z01 Owner's Manual page 10

About the water softening system.
Set Water Hardness Number
Set Regeneration (Starting) Time
10
NOTE: If 15 and HARDNESS (factory default) do not show in the
display, press SELECT until they do.
Press the UP or DOWN button to set your water hardness
1
number in the display. DOWN moves the display down to 1.
UP moves the display up to the maximum setting of 90.
NOTE: Each press of a button changes the display by 1 between
1 and 25. Above 25, the display changes 5 at a time...25, 30, 35, etc.
Holding a button in changes the numbers twice each second.
When the water hardness number shows, press SELECT to set.
2
You can get the grains per gallon (gpg) hardness of your water
supply from a water analysis laboratory, or call and ask your
local water department, if you are on a municipal supply.
NOTE: RECHARGE TIME and a flashing 2:00 AM (factory default)
should show in the display. This is a good time for regeneration to
start (over in about 2 hours) in most households because water is
not in use. HARD WATER is bypassed to house faucets during
regeneration. See the
Regeneration section.
Press the UP or DOWN button to set the desired regeneration
1
start time.
NOTE: Each press of the buttons changes the time by one hour.
Holding the buttons in changes the time twice each second.
Be sure to observe the AM or PM
the time of day.
Press the SELECT button once more.
2
The display shows the present time of day and RECHARGE
TONIGHT
Automatic Hard Water Bypass During
.
as you did when setting