Epson 10020 User Manual page 91

Using DISKCOPY with one drive only
If your computer has only one diskette drive and no hard disk,
follow these steps to copy a diskette:
1. Make sure the diskette you want to copy is write-protected.
(See Chapter 2 for instructions.)
2. Insert the Operating 1 diskette in the diskette drive.
3. At A>
DISKCOPY A: A:
MS-DOS displays this message:
Insert SOURCE diskette in drive A:
Press any key when ready . . .
4. Remove the Operating 1 diskette and insert the diskette
you want to copy (the source) in the diskette drive and
press any key. DISKCOPY copies
diskette to the computer's memory. Then the screen
displays this message:
Insert TARGET diskette in drive A:
Press any key when ready . . .
5. Remove the original diskette from drive A and insert the
blank diskette (the target) in the drive. Press any key. If
new
the
and then copies the contents of
When the copy is
Copy another diskette (Y/N)?
6. Press Y and Enter to copy another diskette or N and Enter
to return to the MS-DOS command prompt.
3-32
Using MS-DOS With Your Computer
prompt, type the following and press Enter:
is not formatted,
diskette
complete, you see this message:
the contents
DISKCOPY formats it
memory to the diskette.
of the