Turning On The Computer - Epson 10020 User Manual

Turning On the Computer

7
Before you turn on your computer, read the following safety
rules to avoid accidentally damaging the computer or injuring
yourself:
Never turn the computer on with a protector card in the
diskette drive.
Do not unplug cables from the computer when the power
switch is on.
Never turn off or reset your computer while a disk drive
light is on. This can destroy data stored on disk or make a
whole disk unusable.
Always wait at least five seconds after you switch off the
power before you switch it on again. Turning the power off
and on rapidly can damage the computer's circuitry.
Do not leave a beverage on top of or next to your system or
any of its components. Spilled liquid can damage the
circuitry of your equipment.
Do not attempt to dismantle any part of the computer.
Only remove the cover to install and remove optional
devices. If there is a hardware problem you cannot solve
after reading the appropriate section in Chapter 5 on
troubleshooting, contact your Epson Customer Care
Center.
Always turn off the power, disconnect all cables, and wait
five seconds before you remove the computer's cover.
Follow these steps to turn on your system:
1. Turn on the monitor, printer, and any other peripheral
devices connected to the computer.
1-14 Setting Up Your Systems