Replacing The Multimedia Board - Gateway NV55 Service Manual

Replacing the multimedia board

60
CHAPTER 3: Replacing notebook components
Tools you need to complete this task:
Phillips #0 screwdriver
Flat screwdriver
Screws removed during this task:
•
3 black M2.5×6 (keyboard cover)
To replace the multimedia board:
1
Complete the steps in
2
Remove the keyboard cover by performing steps
keyboard cover"
Caution
The multimedia board is glued to the keyboard cover. Remove this
board only if it is defective.
3
Insert a small flat-blade screwdriver or non-marring scribe between the
multimedia board and the keyboard cover's underside, and carefully pry the
board loose.
4
Remove the multimedia board from the keyboard cover.
Note
A circuit board that is >10 cm
rectangle as shown in the above image. Follow the local regulations
for disposing this type of circuit board.
or Non-marring plastic scribe
"Preparing the notebook" on page
procedure on page 58.
2
has been highlighted with a yellow
47.
2–6 of the "Replacing the