Table of Contents
Advertisement
8
Remove the barcode sticker on top of the processor.
Discrete model
9
Moisten a soft cloth with isopropyl alcohol and clean the processor die to
remove any thermal grease residue. Wipe the die surface several times to
make sure that no particles or dust contaminants are evident. Allow the
alcohol to evaporate before continuing.
Caution
Do not touch the contact surface of the new cooling assembly nor
the processor dire as this may leave dead skin cells or oils from
your finger that can result in poor thermal grease performance.
10
Apply just enough thermal grease to evenly coat the surface of the processor
die.
11
Place the new cooling assembly on the system board and tighten its captive
screws to secure it in place. Follow the sequence of the number beside each
screw when securing the cooling assembly.
12
Reconnect the cooling fan cable to its system board connector.
13
Reinstall the system board by performing steps
the system board"
14
Reinstall the palm rest by performing steps
rest"
procedure on
15
Reinstall the LCD panel assembly by performing steps
"Replacing the LCD panel assembly"
16
Reinstall the keyboard and the keyboard cover by performing steps
the
"Replacing the keyboard"
17
Close the LCD panel and turn the notebook over so the base is facing up.
18
Reinstall the optical drive by performing steps
the optical drive"
19
Reinstall the hard drive by performing steps
hard drive"
20
If you have disconnected any wireless antennas, reconnect them now.
21
Reinstall the bay cover.
22
Reinstall the battery.
www.gateway.com
procedure on
page
68.
procedure on
procedure on
page
procedure on
page
54.
UMA model
15
and
page
86.
19–21
of the
procedure on
page
page
62.
10
and
56.
8
and
9
of the
16
of the
"Replacing
"Replacing the palm
16–23
of the
64.
5–8
of
11
of the
"Replacing
"Replacing the
91
- Quick Links:
- Memory
Hide quick links:
Advertisement
Table of Contents
