Gateway NV55 Service Manual page 61

5
If your new hard drive already includes the hard drive bracket, go to
If you need to use the bracket from the old hard drive, go to
6
Remove the screws that secure the hard drive bracket, and then detach the
bracket from the drive.
7
Place the bracket on the new drive and secure it with the two screws removed
in step 6.
8
Slide the new hard drive into the hard drive compartment and make sure
it's properly engaged to the SATA1 connector.
9
Secure the new drive to the system board with the screw removed in
10
Reinstall the bay cover.
www.gateway.com
step 8.
step 6.
step 6.
55