Epson R-D User Manual page 11

When using a memory card
❏ Only memory cards designed for the product's specifications can
be used.
❏ The methods for using memory cards vary according to card type.
Be sure to refer to the documentation included with your memory
card for details.
❏ Do not remove the memory card while the power switch is on.
When using the LCD
❏ The LCD monitor on this product may contain a few small bright
or dark spots. These are normal and do not mean that your LCD
monitor is damaged in any way.
❏ If the LCD monitor on this product is damaged, consult your
dealer.
❏ If the liquid crystal solution contained in the LCD monitor on this
product leaks out and gets onto your hands, wash them thoroughly
with soap and water. If it gets into your eyes, flush them
immediately with water. If discomfort or vision problems remain
after a thorough flushing, see a doctor immediately.
❏ Only use a soft, dry cloth to clean the display. Do not use liquid or
chemical cleaners.
When storing, maintaining, or transporting the
camera
❏ Do not store this product outdoors.
❏ Do not store this product near water.
❏ Do not store this product in a location subject to high temperature
or humidity.
❏ Do not store this product in a location subject to rapid changes in
temperature or humidity.
❏ Do not store this product in a location subject to direct sunlight or
strong light sources.
For United Kingdom, Hong Kong, and Singapore
users
Replace fuses only with fuses of the correct size and rating.
For United Kingdom users
Safety information
Warning:
w
Refer to the rating plate for voltage and check that the appliance voltage
corresponds to the supply voltage.
Important:
The wires in the mains lead fitted to this appliance are coloured in accordance
to the following code:
Blue - Neutral
Brown - Live
If you have to fit a plug:
As the colours of the mains lead of this appliance may not match coloured
markings used to identify the terminals in a plug, please proceed as follows:
The blue wire must be connected to the terminal in the plug marked with the
letter N.
The brown wire must be connected to the terminal in the plug marked with the
letter L.
If damage occurs to the plug, replace the cord set or consult a qualified
electrician.
6
Introduction