Starting Up And Terminating Procedure Of Debugging - Epson S1C33 Series Operation Manual

3.3 Starting Up and Terminating Procedure of Debugging

Follow the procedure below to start debugging.
1. Make sure the power of the target board and personal computer are off.
2. Connect the S5U1C330MxD1 board to the target board in which the debug monitor is implemented and connect
the S5U1C330MxD1 board to the personal computer with the RS232 cable.
3. Turn the target board on and then start the debug monitor.
4. Turn the personal computer on and start the debugger db33 in debug monitor mode from the work bench wb33 or
DOS prompt.
Example: db33 -mon -b 115200 -p 33104_m.par
Follow the procedure in order from Step 4 to Step 1 to terminate debugging and for power off.
Note: When connecting and disconnecting the RS232C cable, make sure the target board and the
personal computer are off.
S1C33 FAMILY DEBUG MONITOR
OPERATION MANUAL
3 TARGET PROGRAM AND DEBUGGING
EPSON
11