Advertisement
STEP 8:
(SEE FIGURE 8)
*
Assemble the two iNNER hitch braces to flow control
mounting tube using a 1/4" x 1-3/4" hex bolt (B) and a
1/4" nylock hex nut (C). DO NOTTIGHTEN YET.
=
TIGHTEN all nuts and bolts assembled up to this
point. Do not collapse the tubes when tightening.
(C) 1/4" NYLOC_
HEX
HITCH BRACE
(iNNER)
FLOW CONTROL-
MOUNTING TUBE
HITCH BRACE
(iNNER)
FIGURE 8
STEP 9:
(SEE FIGURE 9)
•
Push on flow control arm to "OFF" position.
Slide flow control mounting bracket along tube until
closure plate in bottom of hopper just closes.
Snug the 5/16" nylock hex nuts just enough to
hold flow control mounting bracket in place.
Set adjustable stop at "5". Pull flow control arm
against stop. Verify that closure plate has opened
about half way.
If closure plate does not open half way, adjust position
of flow control mounting bracket until closure plate will
open about half way at "5" and will still close when
arm is locked in "OFF" position. Tighten the 5/16"
nylock hex nuts.
FLOW
CONTROL
ARM
ADJUSTABLE
STOP
(SETTING "5")
FIGURE 9
6
Call 1-866-576-8388
for missing parts or assembly help
DO NOT RETURN TO STORE
Advertisement
