How To Remove The Top Cover; How To Remove The Belt Cover - Craftsman 536.881400 Operator's Manual

[.,,."_o,,_ F_I Z IB]P'_"_
HOW TO REMOVE THE TOP COVER
There are no adjustments under the top
cover. To clean the engine cooling sys-
tem, follow the steps below to remove
the cover.
1. Remove screws A that attach the
rod support clamp the the top cov-
er. Pivot crank assembly rod up
and lay on unit.
2. Remove screws B.
3. Remove attachment screws C.
4. Remove the top cover,
5. To install the top cover, reverse the
above steps.
A C
/ /
Crank
Assembly
Rod
Top
Cover
Figure lz
HOW TO REMOVE THE BELT COVER
1. Remove the screws A and nuts B
from the belt cover,
2. Remove attachment screw C from
the rear of the belt cover.
3. Remove the belt cover from the
unit.
4. To install the belt cover, reverse the
above steps.
NOTE: The belt cover has belt guides
moulded onto the inside of the cover. When
you install the belt cover, engage the auger
drive lever to tighten the belt against the
pulley. This wil! provide adequate clearance
for the belt guides when installing the belt
cover.
C
/
F-051009C
B
B
A
18
Belt Cover
A A
A Figure 15