To Remove Battery Pack - Craftsman 315.101532 Operator's Manual

3/8 in,, 14.4 volt right angle drill-driver variable speed/reversible
Table of Contents

Advertisement

CHARGING A HOT BATTERY PACK
When using the tool continuously, the batteries in the
battery pack will become hot. You should let a hot bat-
tery pack cool down for approximately 30 minutes before
attempting to recharge. When the battery pack becomes
discharged and is hot, this will cause the green LED to
come on instead of the red LED. After 30 minutes, reinsert
the battery pack in the charger. If the green LED continues
to remain on, return battery pack to your nearest Sears
Repair Center for checking or replacing.
NOTE=This situation only occurs when continuous use of
the tool causes the batteries to become hot. It does not
occur under normal circumstances. Refer to "CHARG-
ING A COOL BATTERY PACK" for normal recharging
of batteries. If the charger does not charge your battery
pack under normal circumstances, return both the battery
pack and charger to your nearest Sears Repair Center for
electrical check.
TO INSTALL
BATTERY
PACK
See Figure2.
_1,
WARNING: Battery tools are always in operating
condition. Therefore, the switch should always be
locked when not in use or carrying at your side,
• Lock the switch trigger on the drill by placing the
forward/reverse selector in the center position.
• Place the battery pack in the drill. Align the raised rib
on the battery pack with the groove inside the drill.
• Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured in the
drill before beginning operation.
CAUTION: When placing the battery pack in the
drill, be sure the raised rib on the battery pack aligns
with the groove inside the drill and latches snap into
place properly. Improper assembly of the battery
pack can cause damage to internal components.
TO REMOVE BATTERY PACK
See Figure 2,
Lock the switch trigger on the drill by placing the
forward/reverse selector in the center position.
• Locate the latches on the side of the battery pack and
depress to release the battery pack from the drill.
• Remove the battery pack from the drill.
LATCHES
DEPRESS L ATCHES T O
RELEASE B ATTERY P ACK
Fig. 2
11

Advertisement

Table of Contents
loading

Table of Contents