Table of Contents
Advertisement
REVERSIBLE
See Figure 3.
This tool has the feature of being reversible. The
direction of rotation is controlled by a selector located
above the switch trigger. With the drill held in normal
operating position, the direction of rotation selector
should be positioned to the left of the switch for
drilling. The drilling direction is reversed when the
selector is to the right of the switch. When the selector
is in center position, the switch trigger is locked.
CENTERPOSITION
(LOCK)
SELECTOR
REVERSE
BATTERY PACK
LATCHES
SWITCH
f
TRIGGER
FORWARD
Fig. 3
,_
CAUTION:
To prevent gear damage, always
allow chuck to come to a complete stop before
changing the direction of rotation.
To stop, release switch trigger and allow the chuck to
come to a complete stop,
TO INSTALL
BAI-FERY
PACK
See Figure 4,
•
Lock switch trigger on your drill by placing the
direction of rotation selector in center position,
See Figure 2.
•
Place battery pack in your drill, Align raised rib
inside drill with groove on battery pack.
See Figure 4.
DEPRESS LATCHES TO
RELEASEBATTERY PACK
Fig. 4
Make sure the latches on each side of your
battery pack snap in place and battery pack is
secured in drill before beginning operation.
_k
CAUTION:
When placing battery pack in your
drill, be sure raised rib inside drill aligns with
groove on battery pack and latches snap in place
properly. Improper assembly of battery pack can
cause damage to internal components.
TO REMOVE BATTERY PACK
•
Lock switch trigger on your drill by placing the
direction of rotation selector in center position.
See Figure 2.
•
Locate latches on end of battery pack and
depress to release battery pack from your drill.
See Figure 4.
•
Remove battery pack from your drill.
8
Advertisement
Table of Contents
