Troubleshooting; Accessories - Gardena ErgoCut 48-Li Operating Instructions Manual

Cordless hedge trimmer
Table of Contents

Advertisement

7. Troubleshooting

Fault
Hedge trimmer does not start
Hedge Trimmer does not
start / starts only briefly.
Hedge is not cleanly cut
Charging indicator lamp does
not light up
Charging indicator lamp
flashes for more than
1 hour
The battery can no longer
be charged
In the event of other faults please contact GARDENA Service.
Repairs should only be carried out by GARDENA service centres or dealers
A
authorised by GARDENA.

8. Accessories

GARDENA
Replacement Battery
Li-Ion 18 V
GARDENA
Quick Battery Charger
GARDENA Maintenance Oil
DANGER ! Risk of physical injury !
Cutting injuries can be caused if the hedge trimmer
A
does switch on unintentionally.
V Remove the battery before maintenance (see
3. Operation) and slide the protective cover
over the cutter blade.
Possible cause
Battery is flat.
Battery not pushed onto
the handle properly.
Hedge Trimmer overheats.
Blade blunt or damaged.
Battery
not plugged in properly.
A fault has occurred.
Battery is defective.
Only the original GARDENA Replacement Battery 18 V
(Art. 8835 / 8839) may be used. This can be obtained from
your GARDENA dealer or directly from GARDENA Service.
Battery for additional duration or for
replacement 1.6 Ah (approx. 60 Min.) /
2.6 Ah (approx. 100 Min.)
Charging the batteries up to three
times faster.
Extends the life of the blade.
Remedy
v Charge battery (see
3. Initial Operation).
v Push battery onto the handle
and make sure that the
locking buttons snaps in
correctly.
v Let Hedge Trimmer cool for
30 seconds.
v Have blade replaced by
GARDENA-Service.
v Plug in battery charger and
charging cable properly.
v Unplug and reinsert
charging cable. The fault
will be reset.
v Replace the battery
(Art. 8835 / 8839).
Art. 8835 / 8839
Art. 8831
Art. 2366
0
17

Advertisement

Table of Contents
loading

This manual is also suitable for:

8878

Table of Contents