Table of Contents
Advertisement
3. Initial Operation
Charging the battery :
3
2
2
6
5
14
WARNING !
Overvoltage damages batteries and the battery
A
charger.
V Ensure the correct mains voltage.
Before using for the first time, the battery must be fully charged.
Charging time (for uncharged battery) see 9. Technical Data.
1
The lithium-ion battery can be charged in any state of charge,
and the charging process can be interrupted at any time without
harming the battery (no memory effect).
So that the fully charged battery is not discharged, the battery
should be disconnected from the battery charger.
1. Press the locking buttons in
the handle
2. Plug the plug of the charger cable
3. Plug battery charger
Charging indicator lamp
The battery is being charged.
Charging indicator lamp
The battery is fully charged.
(For charging time, see 9. Technical Data.)
4
4. First remove the charging cable
and then unplug the battery charger
5. Push the battery
Avoid exhaustive discharge :
Do not wait until the blade comes to an absolute stop (battery
totally discharged) as this shortens the battery life.
v If the output of the hedge trimmer decreases noticeably,
charge the battery.
If the battery has been totally discharged, the LED will flash at
the start of charging. If the LED is still flashing after an hour, a
fault has occurred (see 7. Troubleshooting).
1
and remove the battery
3
.
5
into a mains socket.
6
lights up red :
6
lights up green :
4
2
from bottom onto the handle
2
4
2
into the battery
.
from the charging socket
5
from the mains socket.
3
.
from
Advertisement
Table of Contents
