Print Tests; Input/Output Source Print Tests - Lexmark Optra Color 1200 Service Manual

5050-001
Thermistor Rank
If you replace the transfer belt unit or the EEPROM for the engine
controller, the Thermistor rank value must be set according to the
color of the lead line color.
To set this value:
1. Select Diagnostic Mode.
2. Select Printer Setup.
3. Select Thermistor Setup.
4. Enter the value from the following table.
0
1
2
3
4
Transfer Belt Adjustment
This menu allows you to select how long you would like to run the
transfer belt for testing. Whenever you replace a transfer belt you
have to run the transfer belt to make sure that it is tracking correctly.

Print Tests

Input/Output Source Print Tests

The Diagnostic PRINT TESTS menu is used to verify that the printer
can print on media from each of the installed input sources. Each of
the installed sources is listed as an option within this menu. For each
source, the user has 2 choices:
•
Single (print Print Test pages once),
Blue
Black
Red
Yellow
Green
9.057
9.515
10.000
10.51
11.06
Diagnostic Aids
3-15