Paper Exit Fu/Fd Service Check - Lexmark Optra Color 1200 Service Manual

5050-001
The paper has exited the registration roll and entered the fuser.
1 • Transfer Belt
Unit
• Rear Paper
Guide
• Discharge
Brush
• Fuser Roller
• Fuser Press
Roller
2 Fuser
Separation
Pawl
The paper has entered the fuser and exited the printer.
1 • Fuser Roller
• Fuser Press
Roller
• Fuser
Separation
Pawl
2 • Fuser Exit
Lower roller
• Exit Guide
• FU/FD Flap
Solenoid
• Exit Flap
Clutch Lever
• Gears
• Fuser Exit
Upper Roller

Paper Exit FU/FD Service Check

1 FU/FD Sensor
Actuator
2-34
Service Manual
Remove any buildup of toner. Replace and
damaged or worn parts.
Be sure the separation pawls do not have any toner
built up on the tips. Replace any damaged or worn
parts.
Remove any toner buildup and replace any worn or
damaged parts.
Be sure the exit FU/FD solenoid energizes in the
correct position for either face down or face up
delivery. Replace any damaged or worn parts.
Do a continuity check of the solenoid. Be sure
connector CN122 is properly connected to the
printer controller board.
If the paper is not exiting to the back paper face up
tray or the face down tray, check the sensors.