Drive 2 Stepper Motor Service Check; Transport Belt/Bud Service Check - Lexmark Optra Color 1200 Service Manual

5050-001

Drive 2 Stepper Motor Service Check

1 Drive 2
Stepper Motor
2 Drive 2
Stepper Motor
Unit

Transport Belt/BUD Service Check

1 • BUD
Sensors
• BUD
Actuator
2 BUD Motor
3 BUD Lift Cams
4 Printer
Controller
Board
Be sure connector C112 on the printer controller
board is firmly connected. If you still have the
problem, replace the drive 2 stepper motor
(11G0260).
If the drive 2 stepper motor rotates and the fuser,
and exit rolls do not rotate, replace the drive 2
stepper motor unit (11G0258).
Check the transfer belt BUD sensor. Replace the
sensor or the actuator if necessary.
Be sure connector CN106 is firmly connected.
Replace the BUD unit if necessary (11G0254).
Check and replace the BUD lift cam shaft if
necessary (11G0267).
If you still have the problem, replace the printer
controller board (11G0324).
Diagnostic Information
2-29