Replacing The Photoconductor - Epson AcuLaser CX11NF Basic Manual

9. Close cover A.
10. Check for toner messages on the LCD screen. If another toner cartridge needs to
be replaced, you see another error message. Repeat steps 2 to 9 to replace the other
cartridges.

Replacing the Photoconductor

Handling Precautions
Always follow these precautions when replacing the photoconductor:
■
The photoconductor weighs 6.16 lb (2.8 kg). Be sure to hold it firmly by the
handle when carrying it.
■
Avoid exposing the photoconductor to light any longer than necessary.
■
Be careful not to scratch the surface of the drum and belt. Also, avoid touching
the drum; oil from your skin may permanently damage its surface and affect print
quality.
■
Do not store the photoconductor in an area subject to direct sunlight, dust, salty
air, or corrosive gases (such as ammonia). Avoid locations subject to extreme or
rapid changes in temperature or humidity.
■
Do not tilt the photoconductor.
Warning:
Keep the photoconductor out of the reach of children.
Do not dispose of a used photoconductor in fire, as it may explode and cause injury.
Dispose of it according to local regulations.
86
Maintenance