Advertisement
TO AI-I'ACH BA'I-I'ERYPACKTO DRILL
See Figure 3.
Note: Battery pack is shipped in a low charge condition.
Therefore, it must be charged priorto use. Refer to page 9,
"CHARGING BATTERY PACK" for charging instructions.
•
Lock the switch trigger by placing the direction of
rotation selector in center position. See Figure 10.
•
Align raised ribs on battery pack with grooves on
bottom of drill, then attach battery pack to drill as
shown in Figure 3.
•
Make sure latch on battery pack snaps into place and
battery pack is secured to drill before beginning
operation.
TO REMOVE
BATTERY
PACK FROM
DRILL
See Figure 4.
•
Lock the switch trigger by placing the direction of
rotation selector in center position, See Figure 10.
•
Depress latch located on front of battery pack (1) to
release battery pack.
•
Pull forward on battery pack (2) to remove from drill.
DEPRESSLATCHTO
RELEASEBATTERYPACK
LATCH
\
RAISEDRIBS
GROOVES
PULL
TO REMOVE
BATTERYPACK
Fig. 4
BATTERYPACK
Fig. 3
CAUTION:
When attaching battery pack to your
drill, be sure raised ribs and grooves align properly
and latch snaps into place properly. Improper
assembly can cause damage to drill and battery
pack.
8
Advertisement
