Fujitsu ServerView Respurce Orchestrator Virtual Edition V3.1.0 User Manual page 164

with Resource Orchestrator.
The testing method for automatic server recovery is the same as for manual server switchover. Make sure the server is operational by
performing the manual server switchover test.
For details on switchover and failback methods, refer to "Chapter 4 Server Switchover" in the "Operation Guide VE".
Note
For servers other than those using I/O virtualization and those with WWN settings registered, the following checks will not be enabled.
-
[Power off forced when the server is switched over] checkbox
-
[Switchover to server where VM guest exists] checkbox
[VM Host]
The automatic startup of VM guests after the switchover of their VM host depends on their virtual machines' startup configuration within
the server virtualization software used.
For details, refer to the manual of server virtualization software.
Depending on the server virtualization product used, a newly created VM guest may require some reconfiguration before running a server
switchover.
Refer to "D.2 Configuration Requirements" in the "Design Guide VE" for details on such settings.
[Solaris Zones]
To change the zone status after server switchover, when zones have been created in a ZFS storage pool
When a zone has been created in a ZFS storage pool, change the status to enable use of the imported ZFS storage pool, and the zone on
the ZFS storage pool after server switchover.
When changing the status, create the following definition files:
Use the zpool command to check ZFS storage pools.
Use the zoneadm command to check zones.
For details, refer to the manuals described in "2.4.2.1 Required Basic Software" in the "Design Guide VE".
Storage Location of the Definition File
[Windows Manager]
Installation_folder \SVROR\Manager\etc\customize_data
[Linux Manager]
/etc/opt/FJSVrcvmr/customize_data
Definition File Name
zpool_and_zone_recovery.rcxprop
Definition File Format
Describe the definition file as below:
1.
Enter the admin IP address of the switchover source server for ADMIN_IP key value.
2.
Insert a line break, and enter the ZFS storage pool on the server and the zone in the ZFS storage pool, separated by commas
(",").
If it is not necessary to boot the zone, the zone specification can be omitted.
When specifying two or more ZFS storage pools, enter the pools in separate lines using line breaks.
Until the following is specified, everything will be considered the ZFS storage pool and the zone of the server described in the
ADMIN_IP key value.
-
Another ADMIN_IP key
-
End of the file
Each line is entered in the following format.
- 149 -