Chassis Power Control - Fujitsu ServerView Respurce Orchestrator Virtual Edition V3.1.0 User Manual

[Windows]
-
Take caution regarding the following points when shutting down or rebooting a managed server running a Windows operating system.
-
If Windows is not configured to shut down when the computer's power button is pressed, the power operations in Resource
Orchestrator may not function properly.
To check this option, access the Control Panel, open the [Power Options], and check the settings of the [Advanced] tab in the
[Power Options Properties] window.
-
If a file is being edited by a logged-in user, a dialog prompting the user to save the file is displayed, and the system may not shut
down immediately.
In such cases, shutdown does not take place until the user takes the appropriate action or a specified time (approximately five
minutes) has elapsed.
[OVM for SPARC]
When the function is not supported by Oracle VM Server for SPARC, stopping and rebooting of the VM guest cannot be performed.
Based on the virtual machine status, either directly operate the virtual machine, or perform a forced stop or forced reboot.
[VM Host]
-
Take caution regarding the following points when powering-off or rebooting a VM host.
-
When using a server virtualization software's high-availability feature, confirm that the server is set to VM maintenance mode
within that virtualization software. This can be confirmed from the virtualization software client.
-
Perform power operations only after setting VM maintenance mode (either from the VM management software client or using
the resource control command).
Refer to the server virtualization software manual, or to "3.2 rcxadm server" in the "Reference Guide (Command) VE" for details.
Depending on the server virtualization software used, some restrictions may apply to the use of VM maintenance mode settings.
For details about such restrictions, refer to "D.3 Functional Differences between Products" in the "Design Guide VE".

14.2 Chassis Power Control

This section explains how to remotely control the power state of a chassis.
Power operations are only possible for PRIMERGY BX server chassis.
The power state of a blade chassis can be controlled using the rcxadm chassis command.
For details, refer to "3.1 rcxadm chassis" in the "Reference Guide (Command) VE".
- 112 -