Rip Configuration - NetComm NB1300 PLUS 4 User Manual

RIP Configuration

The RIP Per Interface Configuration page allows the user to set the configuration for each
Interface (PVCs, PPP Sessions, USB and LAN).
Interface: This field allows the user to choose the Interface (PVCs, PPP Sessions, USB and
LAN), for the RIP to be configured.
Enable: This field allows the user to Enable (Yes) or Disable (No) the specified interface for
RIP.
Supplier: This field allows the user to select the Supplier Mode (RIP Transmit).
❏
Disabled: The supplier transmit is disabled.
❏
V1 BC: The supplier transmits in RIPv1 Broadcast.
❏
V2 BC: The supplier transmits in RIPv2 Broadcast.
❏
V2 MC: The supplier transmits in RIPv2 Multicast.
Listener: This field allows the user to select the Listener Mode (RIP Receive)
❏
V1: The listener receives the RIPv1 only.
❏
V2: The listener receives the RIPv2 only.
❏
V1+V2: This listener receives the both RIPv1 and RIPv2.
Supplier and Listener are based on section 4.1 "Compatibility Switch" in RFC 1723.
Current RIP Settings: This field displays the each interface's RIP status.
www.netcomm.com.au
Page 54
Rev. 1- YML674
NB1300Plus4 ADSL Modem