Advertisement
•
Terminal bases and I/O modules, complete list of terminal
bases and I/O modules in the National Instruments online
catalog at
•
Cables
•
24 VDC power supply
Installation
Caution
bases, make sure that power is not applied to the FP-1600
while you install or remove terminal bases.
Follow these steps to install the FP-1600:
1. Use a flat-bladed screwdriver to open the DIN rail clip to the
unlocked position, as shown in Figure 1.
Rail Clip Unlocked
Note
your FP-1600 before you mount your FP-1600. You will
need this information when you configure the FP-1600.
2. Mount the FP-1600 onto a 35 mm DIN rail or onto a panel
mount accessory.
•
Installing onto a DIN rail:
a. Hook the lip on the rear of the FP-1600 onto the top of
a 35 mm DIN rail and press the FP-1600 down onto the
DIN rail, as shown in Figure 2.
FP-1600
www.natinst.com
To avoid damaging the FP-1600 and the terminal
Figure 1. DIN Rail Clip
Write down the serial number from the back of
Rail Clip Locked
2
www.natinst.com
Advertisement
