Table of Contents
Advertisement
Powering Up
Figure 2-3
Powering Up
Simply plug one end of the power cord into the unit, and the other end into a grounded
AC power source. Units are typically connected to a power strip or other power outlet
that may be cycled on and off. An uninterruptible power supply may also be used.
Check to make sure each module installed displays a green Power LED (see Figure
Verify that any module that does not display a green Power LED is properly seated in the
chassis backplane.
If problems exist, refer to the troubleshooting checklist in Chapter
If you require assistance, contact Enterasys Networks using one of the methods described
in "Getting Help" on page xii.
2-4 Installation and Connection
Typical Configuration for a Mid-Span Power Hub
Layer 3 Switch
Enterasys BL-69108ENT
or BL-69524ENT (shown)
Mid-Span Power Hub
Powered Devices
IEEE802.3af Compatible
3, Troubleshooting.
2‐4).
Advertisement
Table of Contents
Need help?
Do you have a question about the Mid-Span Power Hub BL-6000ENT and is the answer not in the manual?
Questions and answers