Unpacking - Craftsman C950-52919-0 Owner's Manual

ASSEMBLY
Figure 1 shows the snow blower in the shipping position.
Figure 2 shows the snow blower completely assembled.
Reference to right and left hand side of the snow blower is
from the operator's position at the handle.
UNPACKING
1. Locate and remove the fuel stabilizer and the parts bag.
NOTE: Place fuel stabilizer in a safe place until
needed for storage.
2. Cut and discard the plastic ties securing the chute crank
assembly to the top pallet, place chute crank assembly
aside. Discard pallet.
3. Locate all parts packed separately and remove from car-
ton.
4. Cut all four corners of the carton from top to bottom and
lay the panels flat.
5. Remove and discard the packing material from around
the snow blower. Cut any straps that are holding snow
blower to lower pallet.
6. Roll the snow blower off the carton by pulling on the lower
handle.
CAUTION: DO NOT back over cables.
7. Remove the packing material from the handle assembly.
8. Cut ties securing the clutch control cables to the lower
handle.
NOTE: If the cables have become disconnected from the
clutch levers, reinstall the cables as shown in Figure 3.
o o
Auger Drive
Clutch Lever
Assembly
Speed
Selector
Lever
Auger
Drive
Cable
Traction Drive
Clutch Lever
Traction
Cable
Crank
Y
!
Height Adjust
Skid
Snow Chu_
Deflec_r
_r Housing
!l
Figure 1
Figure 2
Traction Drive Lever
Figure 3
F-001005J 7