Craftsman 486.245313 Owner's Manual page 6

• Assemble t helargeandsmall s praygunclipsto the
sideofthetankusingtwo#10x 1/2"screws and#10
lockwashers. Seefigure7.
#10 x 1/2"
SCREW
#10 LOCK
WASHER
SPRAY GUN
CLiP (LARGE)
SPRAY GUN
CLIP (SMALL)
FIGURE 7
COILED HOSE CLAMP
',\\\
318"HOSE CLAMPS
FIGURE 8
HOSE
VIEWED FROM FRONT
To connect the wire harness to the tractor, attach the
red wire to the positive post on the battery or to the
"HOT" connection on a tractor switch or ammeter.
The brown wire may be grounded or connected to the
negative battery post. See figures 9 and 10.
IMPORTANT: This sprayer should be connected to 12
volt batteries only!
Slide a 3/8" hose clamp onto the boom connecting
hose. Place the end of the hose through the conduit
clamp (attached to the pump) and then slide a second
3/8" hose clamp onto the hose. Leave hose clamps
loose for now. See Figure 8.
Push the hose onto the hose adapter in the end of
the "On-Off" valve. Tighten the hose clamp around the
hose and adapter. See figure 8.
Position the valve and hose clamp up against the
conduit clamp. Slide the other hose clamp against the
other side of the conduit clamp. Tighten the clamp
without collapsing the hose. See figure 8.
Slide the coiled hose clamp onto the spray gun hose
and then push the hose onto the hose adapter on the
1/4" tee fitting. Tighten the hose clamp around the
hose and adapter. See figure 8.
Snap the spray gun into the clips on the front of the
tank. (The large clip holds the spray gun handle and
the small clip holds the wand.) Refer to figure 7.
PUMP SWITCH QUICK COUPLER
BROWN
FIGURE 9
DANGER! Never allow negative pin on
plug to come in contact with positive
"hot" post on battery. Fire or explosion
may result!
POSITIVE
"HOT"
POST
NEGATIVE
POST
12 VOLT TRACTOR BATTERY
FIGURE 10