Configure Snmp; Vpn Site-To-Site Sample Configuration - Enterasys X-Pedition XSR-3020 Getting Started Manual

VPN Site-to-Site Sample Configuration

Configure SNMP

The previously configured ACL will be applied to all SNMP requests. Stricter ACLs can be written
if tighter security controls are required.
XSR(config)#snmp-server community toMonitor1 ro 26
+
Adds an SNMP community with read-only privileges attached to ACL 26
XSR(config)#snmp-server community toConfigure1 rw 26
+
Adds another SNMP community with read-write privileges attached to ACL 26
XSR(config)#snmp-server enable traps
+
Enables traps to be transmitted
XSR(config)#snmp-server contact support@enterasys.com
+
Specifies contact information for the management server
XSR(config)#snmp location "HQ 2nd floor"
+
Specifies the server locationr
XSR(config)#snmp-server host 192.168.2.101 traps trapCommunity
+
Specifies management station to send traps to
XSR(config)#snmp-server host 192.168.2.102 traps trapCommunity
+
Specifies another management station to send traps to
VPN Site-to-Site Sample Configuration
The following VPN topology, shown in
IPSec tunnels with a remote ANG-1105 and two XSRs.
The following script configures the VPN topology shown in
3-26 Software Configuration
Figure 3-5
Central Site
112.16.1.221
XSR
112.16.244.10
Gateway IP address
for all remote sites
Figure 3-5, configures a central site XSR to connect over
VPN Site-to-Site Topology
112.16.244.9
Firewall
112.16.244.7
XSR
ANG-1105
112.16.244.5
112.16.72.2
ANG-1105
Branch Sites
XSR
112.16.76.2
112.16.80.2
Figure 3-5.