Table of Contents
Advertisement
Bootrom Monitor Mode Commands
ff
This command formats the Flash file system. We recommend that you first save any
.cert, .cfg
deleted. You are prompted to enter data by the following script:
XSR-3020: ff
You will lose all files in the "flash:" file system.
Are you sure you want to format the "flash:" file system? (y/n) y
Unlocking flash file sectors
Initializing DOS file system.
Formatting flashrom file system
...................................................... Done.
Set working directory to flash:
Using default Bootrom password. The system is not secure!!!
Use "bp" to change password
ffc
This command formats the CompactFlash card.
ng
This command retrieves a file over the network using a remote IP address/file path.
np
This command modifies network parameters. You are prompted to enter data by the following
script. While most of the options are self-explanatory, three require further description.
•
When set to no, the Autoboot option places the prompt in Bootrom mode when you boot or
power up the XSR.
•
When set to yes, the default Quickboot action of delaying five seconds at startup for you to
optionally enter CTRL-C and acquire Bootrom mode is negated. You can still acquire Bootrom
mode, but you must immediately press CTRL-C upon seeing the X-Pedition Security Router
Bootrom header.
•
The default hostname (local target name), XSR-3000, cannot be changed. In the absence of a
user-supplied hostname via the
prompt and SNMP hostname in MIB-II.
XSR-3020: np
Enter '.' = clear a field; '-' = go to previous field;
Local IP address
Gateway IP address
Remote Host IP address (192.168.1.10)
Remote file path (c:\)
Use TFTP (no)
Ftp userid (anonymous)
Ftp password ()
3-38 Software Configuration
, and your
startup-config
(192.168.1.1)
files to
cflash:
or a PC since any files in
hostname
CLI command, this name will be used as the CLI
:
()
:
:
:
:
:
:
.dat,
flash:
^C = quit
will be
Advertisement
Table of Contents
