Lighting Instructions; To Turn Off Gas To Appliance - England's Stove Works 26-GBVLP Installation And Operation Manual

Englander stoves models: 26-gbvlp 26-gbvng 60-shbvlp 60-shbvng 60-trbvlp 60-trbvng installation & operation manual
Table of Contents

Advertisement

1.
STOP! Read "For Your Safety" above.
2.
Set the thermostat to lowest setting.
3.
Turn off all electric power to the appliance.
4.
This appliance is equipped with a manual
piezoelectric ignition device. Do not attempt
to light the pilot by hand.
5.
Turn gas valve control knob fully clockwise
→ to "OFF."
6.
Wait five (5) minutes to clear out any gas. If
you then smell gas, STOP!
"For Your Safety Read Before Lighting"
information earlier. If you do not smell gas,
go to the next step.
7.
Be sure the thermostat is set at the lowest
setting.
8.
Turn
the
gas
valve
counterclockwise ← to "PILOT."
1.
Set the thermostat to lowest setting.
2.
Turn off all electric power to the appliance if
service is to be performed.

LIGHTING INSTRUCTIONS

Follow the
control
knob

TO TURN OFF GAS TO APPLIANCE

9.
Push in the gas valve control knob and hold
it in while pushing the button of the
piezoignitor.
Push the piezoignitor button
several times while holding the gas valve
control knob in.
10. After the pilot has ignited, you may cease
pushing the piezoignitor button. Continue to
hold
the
gas
valve
approximately 30-60 seconds. Release the
gas valve control knob and it will "pop" out.
If the knob does not pop up when
released, stop and immediately call your
service technician or gas supplier.
The pilot is now lit.
11. For the very first lighting, it may take several
attempts to purge air from the gas line. If
pilot ignition does not occur or the pilot goes
out, repeat steps 9 and 10.
12. Turn the gas valve control knob fully
counterclockwise ← to "ON."
13. Turn on all power to appliance.
14. Set thermostat to desired setting.
15. If the appliance will not operate, follow the
instructions "TO TURN OFF GAS TO
APPLIANCE"
and
technician or gas supplier.
16. Shut the gas valve access door.
3.
Turn gas valve control knob fully clockwise
→ to "OFF." Do not force.
4.
Shut gas valve access door.
1. White Rogers Pilot Light Assembly
(located in the firebox)
2. Spill Switch (located in the draft hood
beneath the flue collar)
3. Wall Thermostat
4. Piezoelectric Spark Ignitor (located near
the gas control valve)
control
knob
for
call
your
service

Advertisement

Table of Contents
loading

This manual is also suitable for:

26-gbvng60-shbvlp60-shbvng60-trbvlp60-trbvng

Table of Contents