General Information; Model Description; Unpacking And Checking Contents - Craftsman 113.248212 Owner's Manual

BOTH MODELS
genera information
1, This manual is for the following models - 113.2482t2
and 113248322. All sections are labeled with the cor-
rect model number: Follow ONLY instructions that are
meant for your model saw,.
2. If you are missing any part(s) while putting your saw
together; do not continue assembly.. Contact your
Sears Service Center or Retail Store and get the miss-
ing part(s) before continuing assembly or trying to use
the saw.
Complete parts lists are located at the end of this man-
ual Use these lists to identify the number of any miss-
ing part.
3. Sometimes small parts get lost in packaging rnateriaIs,.
Do not throw away any packaging until your' saw is put
together If your are missing a part, check packaging
before contacting Soars..
Model Description
Model 113.248212; Manual Band Saw; 18 x 23 inch work
table; single speed; 1/2 H P,.motor' that develops 1 H R,;
legseL
Model 113248322;Manual Band Saw; 27 x 23 inch work
table; two speed; 5/8 H..P motor that develops 1-1/8 H. P;
legset°
unpacking and checking contents
B@TH M@D LS
TOOLS NEEDED
MEDIUM SCREWDRIVER
tf2 PHILLIPS SCREWDRIVER
3/8 WRENCH
7/16 WRENCH
_{L( _ 9/16" WRENCH
SQUARE
3/8" SOCKET _ _ _
7/16" SOCKET
9/16" SOCKET
1.8 HEX L WRENCH
5/32 HEX 'L WRENCH _ SOCKET WRENCH
COMBINATION SQUARE MUST BE TRUE
F
!
f
I
DRAW LIGHT t
LINE ON BOARD
I
ALONG THtS EDGE _"_'T-
L_
/
/
SHOULD BE NO GAP OR OVERLAP HERE WHEN
SQUARE IS FLIPPED OVER iN DOTTED POSITION
STRAIGHT EDGE OF
BOARD 3/4-iNCH THICK
THIS EDGE MUST BE
PE_CTLY STRAIGHT
WARNING: To avoid injury from unexpected
starting or electrical shock, do not plug the saw in
until all assembly and alignment steps are com-
plete. The power cord must remain unplugged
whenever you are working on the saw.
Unpacking and Checking Contents
1 Separate all "loose parts" from packaging materials
and check each item with "Table of Loose Parts" to
make sure all items are accounted for, before discard-
ing any packing material
WARNING: If any parts are missing, do not at-
tempt to assemble the band saw, plug in the
power cord, or turn the switch on until the missing
parts are obtained and are Installed correctly.
2, Remove front table and front cover first while saw is
being unpacked To remove the front cover, pull the
cover at the neck and underside of throat area
8