Error Codes (Mf6550/Mf6560/Mf6580 Only) - Canon imageCLASS MF6500 Series Basic Manual

An error code is a four-digit code shown on an ERROR TX REPORT or an ERROR
RX REPORT when an error occurs.
12/31/2006 10:50 FAX 123XXXXXX CANON i_ @@i
*** ERROR TX REPORT ***
TX FUNCTION WAS NOT COMPLETED
TX/RX NO
RECIPIENT ADDRESS
DESTINATION ID
ST. TIME
TIME USE
PAGES SENT
RESULT
O00S
lllXXXXX
12/31 10:50
00'00
0
NG _BUSY/NO SIGNAL
Error Code
For details on reports, see Chapter 6, "Reports and Lists," in the Advanced Guide.
See the table below for individual error codes.
i
#0001 A document may be jammed. Remove the jammed document.
#0003 - An attempt was made to send a
document of 24 7/8" (630 mm) or
longer from the ADE
A document takes a long time to
send because it contains too
much data.
A document takes a long time to
receive.
Divide the document into smaller
parts and send from the platen
glass.
Reduce the scanning resolution
before sending.
Contact the other party and ask
them to reduce their scanning
resolution or divide the document
into smaller parts for sending.
=s
O
12-12