Driver Installation For Sco Openserver & Unixware; Installing The Sco Openserver Driver - Asus PCI-DA2100 User Manual

6 Driver Installation for SCO OpenServer & UnixWare
The chapter describes how to install SCO UNIX BTLD (Boot Time
Loadable Driver) for the ASUS PCI-DA2100/-DA2200.
6.1

Installing the SCO OpenServer Driver

1. Use the ASUS PCI-DA2100/-DA2200 BIOS Configuration Utility
to disable ISA Mailbox Emulation mode (default is disabled). To
do this, at system bootup, press [Ctrl-I], select Configure Card
option, then change IO Port Address to DISABLED.
2. Use ASUS Text RAID Manager (refer to chapter 6) to configure
Logical Drives and SCSI Devices and map them to valid SCSI-
IDs/LUNs. Note that SCSI ID 7 is reserved for the ASUS PCI-
DA2100/-DA2200 and thus no logical drives or devices should
be mapped to this SCSI ID.
3. Check IO devices, CD-ROM or TAPE drive is properly installed.
4. Insert the N1 boot diskette into the floppy drive and turn on the
PC. When the "boot" message appears, type link as follows:
SCO UNIX System V/386
Boot: link <Enter>
5. Type da2x at the following prompt:
What packages do you need linked in the system,
or 'q' to quit?: da2x
6. You will be prompted to insert the DA BTLD diskette after a
series of messages as follows:
Please insert the fd(x)da2x volume and press <RETURN>
or 'q' to quit:
7. After Insert the diskette, press [Enter].
ASUS PCI-DA2100/PCI-DA2200 User's Manual
Appendix A
169