Os/2 Driver Installation; Installing Driver During Os/2 2.X Or 3.0 Installation - Asus PCI-DA2100 User Manual

Appendix A
®
5 OS/2
Up to 4 ASUS PCI-DA2100/-DA2200 controllers can be installed in
one computer. The following files are supplied for driver installation,
they are put in the \OS2 subdirectory.
-
DA2000.ADD : ASUS PCI-DA2100/-DA2200 OS/2 2.x and
3.0(Warp) Device Driver.
-
DA2000.DDP : Device Driver Profile for driver installation.
-
README.OS2 : An text file describing the ASUS PCI-DA2100/-
DA2200 OS/2 driver.
5.1

Installing Driver During OS/2 2.x or 3.0 Installation

Follow these steps only if OS/2 2.x, 3.0 is not installed on your
computer or if you are upgrading to OS/2 2.x or 3.0.
1. Use the ASUS PCI-DA2100/-DA2200 BIOS Configuration Utility
to disable ISA Mailbox Emulation mode(default is disabled). To
do this, at system bootup, press [Ctrl-I], select Configure Card
option, then change IO Port Address to DISABLED.
2. Use ASUS Text RAID Manager or RS-232 Terminal Interface
Operation to configure Logical Drives and SCSI Devices and
map them to valid SCSI-IDs/LUNs. Note that SCSI ID 7 is
reserved for the ASUS PCI-DA2100/-DA2200 adapter and thus
no logical drives or devices should be mapped to this SCSI ID.
3. Prepare for the installation by using DISKCOPY (or any other
disk-copy utility) to make backup copy of IBM OS/2 installation
diskette #1. Use this copy as your working diskette #1.
4. Copy DA2000.ADD
controller distribution diskette to OS/2 installation diskette #1.
Modify the CONFIG.SYS file on OS/2 installation diskette #1 to
add the following line to the end of CONFIG.SYS:
BASEDEV=DA2000.ADD /V
5. Follow the steps from IBM for installing OS/2.
164
Driver Installation
from
ASUS PCI-DA2100/PCI-DA2200 User's Manual
ASUS PCI-DA2100/-DA2200